RDA (Rebuildable Dripping Atomizers) is used for dripping the e-liquid directly into the coil or wick. Because of no tank available the wick does not remain wet. This means that you need to continue with dripping the e-liquid onto the coil or wick after your few puffs. It may be a bit tedious but then it offers the fresh and cleanest flavor. Besides this because of dripping you can frequently switch to different flavors as you don’t have to full the tank of a particular e-liquid.
If you have ever been near the vaping community for a long time, you are bound to hear about RDA’s (rebuildable dripping atomizers). This equipment seems to be a bit difficult to use but in reality it’s not, you just need practice. The methods to rebuild available on various sites may frighten some of the newcomers. But once you start building your new coil you will realize how easy it is.
The new users must know that there are lots of advantages of using RDA (rebuildable dripping atomizer). The flavor is superb, you get more throat hit, and as mentioned before easy to manage. Things required to rebuild are as follows.
- Rebuildable atomizer
- Safety pin or nail, paper clip.
- Pair of nail clippers
- Pair of pliers
- Screw drivers
- Gauge wire of 2 inch
- Wick – two inch
KUMIHO A6 Steel Rebuildable dripping atomizer RDA is easy to built and clean and is recommended for advanced users as it requires rebuilding and changing of the coil. Stainless drip tip 510/901 and coil of 1.8 ohm comes equipped with this device. In 510, the air is drawn from the bottom and not the side making it similar to atomizers available in market. You can build the coil and wick by yourself and the resistance can be easily changed by adjusting the length of coil. This device comes in with a 60 days Warranty Card from the manufacturer.
It helps people to quit their smoking habit for good.
This device has some great features like those of other expensive products in market. It has a changeable and removable coil battery in which you can change resistance by adjusting the length of coil. Length of this device is 40 mm and Diameter of 14mm. it is made up of stainless steel. 501 or 901 style drips can be used on A6. If the unit does not fire then you need to adjust the center pin to make a proper contact. The cost of this device varies from $5 to $9.95 and can be purchased online on sites like http://www.route66vapor.com/kumiho-a6-atomizer-rda/ or http://www.healthcabin.net/index.php?main_page=product_info&products_id=8580 etc.
RDA is basically for users who are experienced and have basic electronic knowledge to use the device properly. The users should know how different thickness of wicks or coils can vary in (resistance) ohms. Multimeter to verify the ohms of each and every coil that is made is very important. Users having no basic knowledge of lithium and MOD Ion devices cannot use this material safely.Read More